Skip to main content

How to Clean Quartz Countertops and Care for Them

Warm water and mild soap do most of the work on quartz. See what Caesarstone, Cambria, MSI and Silestone say about stains, bleach and hot pans.

Warm water, a soft cloth and a little mild soap will clean quartz most days. That is what Caesarstone, Cambria and MSI all say. Where they split is on the harder stuff: scouring cleaners, bleach, vinegar and solvents. This guide gives the common ground first, then shows where the makers disagree, so you know when to check your own brand.

We sell and install quartz at our showroom in Odessa, so we are not a neutral party. Every point below names the page it came from, and we left out anything we could not read on a live page.

Every day

Wipe with warm water and mild soap. Rinse and dry. Use a cutting board and a trivet.

Now and then

Treat a stain with a gentle cleaner your maker allows. Test a hidden spot first. See stains.

Never

Bleach, oven cleaner, drain cleaner, scouring powder or a sealer. See bleach.

The daily clean: water, soap, a soft cloth

Cambria’s care page says to use a little warm water, a soft cotton cloth and mild soap if you like. Caesarstone says the same in its own words: a soft cloth or non-abrasive scourer, warm water and a mild detergent, then rinse and dry. Cambria adds that the surface is nonporous and nonabsorbent, so residue comes off with that same simple mix.

MSI is a little looser. It says warm water and a dishcloth or soft sponge, and it allows a gentle liquid cleaner for grease, such as Simple Green or plain dish detergent. Silestone’s care sheet, from its maker Cosentino, calls for soap and warm water, and says any pH balanced household cleaner may be used.

Two small habits come up more than once. Wipe wet spills right away, which is Caesarstone’s advice. And rinse, because MSI’s stain guide says to wipe, rinse and dry to keep residue and cloudiness away.

One more from Caesarstone that is easy to miss: do not use the cloth you wash dishes with, since it may carry oils onto the counter.

Stains: what to try first

Start gentle and work up. Most stains on quartz are something sitting on top of the surface, or a dye that has begun to reach the resin, so a patient wipe often beats a harsh product.

Caesarstone says to rub the stain with an approved cleaner and a soft cloth in a circular motion, over an area larger than the stain. Rinse, dry and repeat if you need to. For a dried spill, let water soak on it for several minutes first. Test any product on a hidden spot before you use it.

MSI’s stain guide gives the most step by step help we found:

  • Ink or dye: dab 70% isopropyl alcohol on with a soft cloth, wait about 30 seconds, then wipe with a clean damp cloth.
  • A set stain: mix a paste of three parts baking soda to one part water, leave it for 10 minutes, then brush and rinse.
  • Metal marks and scuffs: MSI uses a white eraser in small circles, and says to test first.
  • Hard water spots: a one to one mix of vinegar and water, only on the spot, no longer than two minutes, then rinse and dry right away.

Notice that the last one is an acid. Caesarstone tells owners to avoid strong acids, and MSI is using a weak one for a short time. So if you reach for vinegar, mix it, time it and rinse it. And if your maker is silent on it, test a hidden spot.

Bleach and harsh cleaners: where the makers differ

This is the question people type into Google, and the makers do not give one answer.

Cambria names bleach, oven cleaners and paint removers among the products to avoid, and says its surface is not chemical-proof. MSI lists bleach, paint thinner and drain cleaner as things that can etch or discolor quartz, and says bleach can leave permanent white spots on dark quartz. Silestone’s care sheet is direct: do not use bleach for maintenance, because if it sits more than 12 hours the surface may lose its sheen.

Caesarstone does not name bleach on its care page. It does say to avoid strong chemicals and solvents, strong acids or alkalis, and oxidizers. Its list also includes oven and grill cleaners, dishwasher detergent, drain products, toilet bowl cleaners and wipes. A missing word is not permission, so we would treat bleach as a no on Caesarstone too.

Then there are the real conflicts. A few that surprised us:

  • Soft Scrub. Caesarstone suggests Soft Scrub Liquid Gel for metal marks and fingerprints. Cambria lists Soft Scrub among the products to avoid.
  • Bar Keepers Friend. Caesarstone allows a small amount of the cleanser for rust and metal marks. MSI says only the liquid kind, only in extreme cases, and only after a test. It advises against the powder.
  • Solvents. The Silestone care sheet lists rubbing alcohol, ammonia, vinegar, mineral spirits, paint thinner and lacquer thinner as cleaners for difficult spots. MSI tells you to keep paint thinner away, and Caesarstone says to avoid solvents.
  • Scrubbing. The Silestone sheet says to scrub stains with a non-scratch pad. Cambria warns against abrasive or harsh scrub pads, and MSI says a melamine sponge needs light pressure and water only, because over pressure or dry use can dull the finish for good.

That Silestone sheet is written for the trade and is an older one, and we could not open a newer page on Cosentino’s website. Makers revise these pages, so look up the current one for your brand and color before you try anything strong.

Our own advice is plain. Begin with soap and water. Move to the gentlest product your maker allows. Do not bring out a solvent or bleach because one page says you can, when two others say you should not.

Hot pans, trivets and sudden heat

Heat is the one place quartz can go wrong fast. All four makers land in the same place on this one.

Caesarstone says to always put hot cookware on a trivet or hot pad. Cambria says sudden temperature changes near the edges, or prolonged heat on the top, can cause damage, and that the product is not heat-proof. It names pots and pans, but also electric frying pans, griddles, slow cookers, air fryers and roaster ovens, and it recommends a closed weave hot pad or a solid trivet.

MSI notes that quartz is scorch-resistant, then says a sudden temperature change can crack it, so do not set hot pans straight on it. The Silestone sheet says hot pans and small appliances should not go directly on the surface, because that can cause scorching, dull areas and cracks. It also says not to use crock pots, electric skillets or griddles directly on it.

None of these pages gives a safe temperature, so we will not make one up. The rule that works in a real kitchen is short: if it came off a burner, an oven or a heating element, it goes on a pad.

Sealers, cutting boards and the sun

Here the makers agree, and it saves you a chore.

Do not seal quartz. Cambria says it never needs sealing, polishing or reconditioning, and that you should not apply sealers or similar treatments under any circumstances, because they wear off and can leave the gloss dull or uneven. MSI says the same: because the stone is non-porous, a sealer sits on top and can wear unevenly. Silestone’s sheet says its sheen is the product’s own, and that sealants and water repellents only give an artificial, short lived shine.

This is one place quartz differs from natural stone. If you are weighing the two, our guide to quartz, quartzite or granite covers how each one is kept up. And if you own granite, do not carry this advice over to it.

Use a cutting board. Caesarstone, Cambria, MSI and Silestone all ask for one. Cambria says a knife slip will dull the knife and not harm the surface, but that cutting straight on the top can leave scratch marks, and no stone surface is scratch-proof. MSI says a cut directly on the counter can dull your knife.

Mind the sun. The Silestone sheet says not to place Silestone outdoors or in places with UV lighting, and warns that the color may suffer over the years from the sun’s rays. Caesarstone’s care page does not address sunlight, and neither does Cambria’s. So we cannot tell you how every brand handles a sunny lanai. If a window or an outdoor kitchen is in your plans, ask about it before you choose a color.

A short routine you can keep

Put it all together and the upkeep for most quartz is small.

  1. After cooking, wipe the counter with warm water and a little mild soap, rinse, and dry.
  2. Keep a trivet by the stove and a cutting board on the counter, where you will actually use them.
  3. Deal with a spill early. Lighter colors show stains more readily, and MSI names tea, coffee, wine, beets and turmeric as the usual suspects.
  4. For a stain, go gentle first, test a hidden spot, and rinse well after.
  5. Keep bleach, oven cleaner, drain cleaner and scouring powder in another room.

Ask before you buy

If you are still choosing, the care page of the brand is worth reading before you pick a color, because the advice above is not the same on every page. Ask us to show you quartz countertop options, and ask which maker made the slab you like. Then read that maker’s care page together. It takes five minutes, and it beats finding out the hard way that a favorite cleaner was on the no list.

If you are choosing new counters, call us. For the full range of work we do, see our countertop page.

Want quartz that stays looking new? Call us and ask how we would set yours up.

Call (727) 376-3333 Or get a free estimate

Where we work

We sell and install quartz from our showroom in Odessa, in Pasco County, and work across Pasco, Pinellas and Hillsborough. Ask us about your kitchen, and about the care page for the brand you pick.

About the author

Andy sells and installs quartz countertops. Andy Tsiouklas is the owner of Trinity Tile and Stone. In Andy's words: "My father has been in the construction field all his life, and I ended up going the same route he did, keeping it in the family."

More about Andy and the company

Related work

If your quartz is still on the wish list, this is the page for the stone and for the work.

Quartz that stays looking new starts with the right habits.

Call(727) 376-3333

Or get a free estimate

Call Now Get a Free Estimate